DETAILS
TECHNICIANS
The
manufacture and installation of a closing in WOOD5 this composing of
perfilería extruida with alloy aluminum 6060 (UNI 9006/1), with
weather T6 (TA 16) and tolerances in dimensions and thicknesses
according to norms UNI 3569. The moldings are made in wood of
tulipier had with plate of noble wood (rivets, walnut, etc.).
The fixed frame has a total depth of 53.9 mm. the movable leaf has a
depth of 76.5 mm, with the height of the tubular camera of 17.5 mm
in the version leaf window and 38 mm in the version leaf reinforced
with the aim to obtain a proportional resistance to the necessity of
the installation.
The system of it
closes hermetic will be of meeting opened with rubbers of central
meeting made in DUTRAL provided with a fin of direct support on the
plane inclined of closing that stops east aim has adapted the leaf
profile. In the inferior crossbeam of frame will be due to carry out
perforations for exit of waters. The unions of the profiles and the
rubbers of central meeting in the angles they would have to be
sealed to each other to avoid the possible ones filtrations of water
and air. Between the wall of the work and the frame, it goes
installed an insulating rubber in angle.
The moldings of wood
they go united to the aluminum structure by means of pieces of
plastic revolving, in the cuts conducted in the molding is advisable
to apply a suitable impermeable sellante.
As
much in profiles of frame like in those of leaf whenever they have
on if installed crystals ventilation drills are due to practice
simultaneously that it empties. The accessories and trimmings will
have to be those that stop series is considered original. The hard
anodizings must have a minimum of 15 microns (UNI 4522-66) and the
lacados ones must be of dust painting of termoendurecido polyester
and cured in furnace.
|
